Instruction manual

Recording settings (User level: ID3)
30 English
It allows you to set the alarm recording and the pre-alarm recording conditions.
1 ALARM RECORDING (Initial setting: OFF)
To set the alarm recording operation mode.
Selections:
OFF: No alarm recording.
ENABLED:
Enables alarm recording at any given point in time
regardless of timer recording.
AL-REC ON TIMER:
Records alarm recording only during timer controlled
recording operation.
AL-REC OFF TIMER:
Records alarm recording outside timer controlled recording
operations.
OLY AL-REC ON TIMER:
Records alarm recording only during the time slot set for the
timer controlled recording.
(Even if a timer controlled recording is set, the standby
mode of the timer controlled recording is not activated.)
2 PICTURE QUALITY (Initial setting: ENHANCED)
It allows you to set the quality of the image recorded by the
DVR.
Selecting a high quality image will result in shortened recording
time.
Selections:
BASIC (Basic image quality)
NORMAL (Standard image quality)
ENHANCED (Enhanced image quality)
FINE (Fine image quality)
SUPER FINE (Super fine image quality)
3 AUDIO RECORDING (Initial setting: OFF)
Audio data can be recorded at the same time as image data.
ON: Audio recording on.
OFF: Audio recording off.
4 ALARM INTERLEAVE (Initial setting: ONLY)
Setting the recording pattern when multiple cameras are
connected to the DVR.
Selections:
ONLY:
Records only the images of the camera that detected the
alarm.
SW:
Records the images of the camera that detected the alarm
and the images of the other cameras alternately.
The 9-channel model will record images as follows when the
alarm is triggered by CH1.
CH1 → CH2 → CH1 → CH3 → CH1 → CH4 →
CH1 → CH5 → CH1 → CH6 → CH1 → CH7 →
CH1 → CH8 → CH1 → CH9
A REC RATE (Initial setting: 15 FPS)
To set the recording rate of the alarm recording.
The letter "A" is displayed in front of the available recording
rate when AUDIO RECORDING is set to "ON".
Available settings:
30, 20, 15, 10, 7.5, 6, 5, 4.286, 3.75, 3.333, 3, 2.727, 2.308, 2,
1.667, 1.429, 1.25, 1.111, 1, 0.5, 0.333, 0.25, 0.2, 0.1, 0.05, 0.033
(Unit: FPS)
B DURATION (Initial setting: 20 SEC)
It allows you to set the duration of the recording once the
alarm has been triggered.
Available settings:
5, 10, 20, 40 SEC, 1, 2, 3, 4, 5, 10, 15 MIN, CC
CC: Records only when an alarm is detected. One alarm will start a
recording of at least 5 seconds.
F
ALARM REC MODE SET
4
5
3
2
1
6
7
A B
A B
• Audio data is recorded in the same recording area as
the images. Therefore, recording time is shortened.
• If recording audio, set the recording rate between
"1 - 30 FPS".