Instruction manual

Network Connection Procedure
English 5
3 Network Operation Screen Display
When the DVR and computer settings are complete, start the Web browser on the computer. The browser should be Internet Explorer
Ver. 5.5 SP2 or higher.
If the computer accesses the DVR following the procedure below, the screen will change to the network operation screen.
1
Enter the connection URL in the address bar of the
browser.
Enter the DVR IP address set in NETWORK SET after http://
and press the [Enter] key. The authentication check dialog
box will display.
2
Enter the user name and password and then click
.
If the user name and password are entered correctly, the
connection to the DVR will complete and the language
selection screen will display.
3
Select a display language from the network
operation screen and click .
The screen will switch to the main screen and network
operations from the computer will be enabled.
Language selection:
English, French, Spanish
When PORT is set to a different value from the initial
"80" append a colon (:) and a PORT number after the
IP address.
<Example when setting PORT to 81>
http://192.168.0.1:81/
• There is no distinction between uppercase and
lowercase.
• If [Remember my password] is checked after entering
the user name and password, entering the password
when connecting can be omitted the next and
subsequent times.
• Because the authentication check dialog box is
displayed when an operation outside the rights is
performed after connecting, it is also possible to
increase the user level while maintaining a connected
state. Cases when there are restrictions on the
connection rights due to restrictions on the number of
simultaneous connections or network settings are
excluded from this. (Refer to P6)
• Concerning the time setting of the DVR
If the current date and time are not set properly on the
DVR, basic operations such as normal recording, timer
controlled recording, camera control will not be
available. It will also hinder the setting of other menus
related to time and date. Therefore, please verify
whether the current date and time are properly set on
the DVR using the CLOCK SET screen. (Refer to P24)
• If [NETWORK STATUS] is "ON" in NETWORK SET of
this device when changing to network operation, the
message " NETWORK CONTROL" will be displayed on
the screen of the monitor connected to the DVR.
• When "Run Time Error" of Java Script displays
while using Internet Explorer
Select the menus in the following order [Tools] →
[Internet Options] → [Advanced Settings] and then
remove the check mark of "Display notification for each
script error" in the browser settings. Check "Do not use
script debugging".
• When a portion of the image is not displayed due to
performance or specifications of the computer.
Within Internet Explorer select from the menus in the
following order [Tools] → [Internet Option] →
"Temporary Internet Files" and then set [Amount of disk
space to use] to less.