User guide

1. Press and hold <FIND> on the base station for more than five seconds, to

put the base station into registration mode. It will stay in registration mode

Press <MENU/OK> and <UP/DOWN> to select REGISTRATION.

Press <MENU/OK> to display PIN?------.

Enter the 4-digit system PIN(default0000).

Press <MENU/OK> to confirm, and the display will show PLEASE WAIT.

If the handset registration is successful, you will hear a confirmation tone and

The handset will automatically be allocated the next available handset number.

This handset number is shown in the handset display in standby mode. If the

handset registration is unsuccessful, the <antenna icon> will still flash.

for about 1 minute, so the following handset sequence must be completed

the <antenna icon> will stop flashing.

within this time.

7.5.1 To register a new handset to your base:

7.5 Registration

You can register additional handsets to have up to five handsets per base unit,

with each handset's number (1 to 5) shown on its display. (Note: each handset

can only be registered to one base.)

IMPORTANT: When you purchase your phone system, all handsets and the

headset are already registered to your base, so you do not need to register

Handset registration is only necessary when you buy extra handset or if a

handset has become faulty.

them.

7.4.6

1. Press <MENU/OK> and <UP/DOWN> to select BS SETTINGS.

2. Press <MENU/OK> and <UP/DOWN> to select

3. Press<MENU/OK> to show CODE, then enter your access digit (1-0) and

PBX ACCESS

If you use the phone on a PBX that needs an access digit to get an external

line, a single digit can be set to dial automatically before any Phonebook or

Calls List number.

PBX ACCESS.

press <MENU/OK> to confirm it and activate the feature.

Note: Press <C/MUTE> to delete any access digit, and deactivate the feature.