User guide

7.6 Reset Your Phone

You can reset your phone to the default settings . After a reset, all your

1. Press <MENU/OK> and <UP/DOWN> to select

DEFAULT.

2. Press <MENU/OK> to display PIN?-----.

3. Enter the 4-digit system PIN(default 0000).

4. Press <MENU/OK> to display CONFIRM?

5. Press <MENU/OK> to confirm, and the phone will be reset to its default

messages will be deleted but your phonebook remains unchanged.

personal settings, call list entries, redial list entries, and answering machine

settings.

1. Press and hold VOLUME UP / FLASH [ + ] together with VOLUME

DOWN [ - ] to put the headset into registration mode. The LED on the

IMPORTANT: The wireless headset is pre-registered when supplied and

should not need to be registered. Headset registration is only necessary when

7.5.2 To register an additional wireless headset

2. Press and hold <FIND> on the base station for more than five seconds, to

3. Place the unregistered wireless headset on the base charging bay.

4. The headset LED will flash blue for about 3 seconds and a long beep tone

Note: If the headset LED flashes slowly in purple, it means that the headset

put the base station into registration mode.

is generated if the registration is successful.

is registered but the base is not available.

wireless headset will toggle between red and blue.

you buy a new headset or if it has lost its registration, and the headset LED is

purple.

Note: Before trying to register a headset to the base station, make sure the

base station system PIN code is set to 0000, otherwise you will not be

able to register the headset