A1 Bidet Sprayer User Manual
TABLE OF CONTENTS PRODUCT INFORMATION Product Installation..................................................4 Parts.................................................................................5 PRODUCT INSTALLATION Pre-Installation...........................................................6 Installation....................................................................7 PRODUCT OPERATION Operation......................................................................12 WARRANTY Warranty..............
FEATURES 4 • High quality ceramic valve • Dual Sprayer • 6” Comfortable handle body • Easy D.I.Y.
PRE-INSTALLATION CAUTION: Do not over tighten any connections. Over tightening connections can cause damage to the parts and cause leaking. INSTALLATION 1. Shut off the water supply to the toilet. • Flush the toilet to drain all water inside the tank. NOTICE: Observe all local plumbing, electrical, and building codes. When installing this unit, be sure that the water supply valve is fully turned off. Failure to do so can result in flooding and water damage. 6 2.
INSTALLATION (CONT.) 3. Reattach your existing toilet supply line. 4. Remove protective plastic covers. 5. Attach the Handheld Bidet to the other end of the supply hose. • As a precaution, slide the level on the handheld bidet sprayer to “off,” which is away from the sprayer head. 6. Mounting Spray • Reattach your existing toilet supply line to the bottom of the T-valve. Be sure all connections are secure, and no leaking or water is present.
INSTALLATION (CONT.) 7. Turn on the water supply valve. • Turn on the water supply valve on the back wall and check for any leaks. Use common plumbers tape if necessary on any leaking threads, reattach and test again. Carefully remove toilet lid and place holder in desired location.
OPERATION How To Use Short Term Non-Use • Open the T-valve to allow water to flow to the Handheld Bidet Sprayer. It is highly recommended that the water supply valve is turned off when not in use. • Direct the Handheld Bidet to the appropriate area and slide the lever to the “on” position. NOTE: • When finished, slide the lever to the “off” position and close the T-valve. If any leaks occur, check all rubber washers and make sure all connections are tight and secure.
WARRANTY Your Bio Bidet is warranted against defects in materials or workmanship for one (1) year from the date of original purchase. Defective parts or a defective product returned to Bio Bidet will be repaired with new or comparable rebuilt parts or exchanged for a Refurbished Bio Bidet as determined by Bio Bidet in their sole discretion. This Iimited warranty given by Bio Bidet covers all defects encountered in normal use of Bio Bidet, and do not apply in the following cases: 1.
Thank You Technical Support/Customer Service 7900 S Route 31 Crystal Lake, IL 60014 T: 847.458.2334 U.S TOLL FREE: 877.339.5214 support@biobidet.com www.biobidet.
