USER MANUAL S400 Pearl S400 Bidet Attachment
Table of Contents Features Dimensions Pre Installation How to use the S400 1
FEATURES Relaxed Fit Panel Comfort Grip Control Dial 2
3
0.
PREINSTALLATION Please be advised that the provided T-Valve should be installed at the fill valve under the toilet tank,NOT down at the water supply coming from the wall. If you do not have access to the fill valve under the toilet tank,contact Biobidet Customer Service at 847.458.2334 and we may be able to provide alternative fittings. Check Water Supply Line Inspect your current water supply line that connects to the toilet tank fill valve to ensure it is a flexible water supply hose.
INSTALLING THE S400 (cont.) 2.Close the water supply valve and flush the toilet completely so that there is little to no water left in the toilet tank. Step 2 3.Disconnect the water hose from underneath the toilet tank. Step 3 4. Connect the 7/8”T-valve to the toilet fill valve where you just removed the water hose from. a. Make sure the rubber washer is properly seated and the narrow side is up. Step 4 5. Attach the water supply hose that comes from the water shut off to the bottom of the T-Valve.
INSTALLING THE S400 (cont.) 6. Connect the metal hose we supplied to the open side of the T-valve. Step 6 7. Insert the rubber non-slip mats to the bottom of the bidet and place the circular mounting brackets into the bidet attachment. Step 7 8. Place the bidet on the toilet with the mounting brackets over the mounting bolt holes and make any needed adjustments to make sure the bidet is centered on the toilet and so you can see the mounting bolt holes through the mounting brackets of the bidet.
INSTALLING THE S400 (cont.) 9.Place the toilet seat back on the toilet over the bidet and secure the bolts down so that the seat and bidet attachment are stable. Step 9 10.Connect the hose from step 6 to the bidet water connection underneath the handle of the bidet. Step 10 11.Slowly turn the water supply valve back on and check for leaks and test the unit for functionality. Step 11 12.
HOW TO USE THE S400 For back wash turn the control knob to front/feminine CLEANING THE S400 Your S400 is made with a higher grade fire-retardant ABS resin. Using hard cleaning chemicals can weaken the material causing it to damage and develop cracks. Clean the bidet by wiping the surface area with a damp cloth regularly. Do not use harsh detergents or any clenaing tools with bristles on your bidet. Steam cleaning is the preferred cleaning method for your bidet.
Warranty Your Bio Bidet is warranted against defects in materials or workmanship for one (1) year from the date of original purchase. Defective parts or a defective product retuned to Bio bidet will be repaired with new or comparable rebuilt parts, or exchanged for a refurbished Bio Bidet product as determined by Bio Bidet in their sole discretion. This limited warranty given by Bio Bidet covers all defects encountered in normal use of this Bio Bidet product, and does not apply in the following cases: 1.
Technical Support/Customer Service Bio Bidet 7900 S IL Route 31 Crystal Lake IL 60014 T: 847-458-2334 Toll Free: 877-339-5214 support@biobidet.com www.biobidet.
