Operating instructions

Maintenance – Mowing Units
331
Pos: 28.24.13.1 /Ü berschriften/Ü berschriften 3/K-O /Ölwechsel @ 0\mod_119 7021941955_ 78.doc @ 161 39
14.13.4 Oil change
Pos: 28.24.13.1 / BA/Wartung/M ähwerke/Ölwec hsel Mähholm Big M 400 @ 0\mod_1197026 735955_78.doc @ 16203
BMII-363
1
2
Fig. 292:
• Lift the mowing unit slightly and set a wooden beam underneath on the opposite side of
the cover (2).
• Lower the mowing unit so that the cutter bar is resting on the wooden beam.
• Switch off the engine, remove the ignition key, and secure the machine from rolling away.
• Collect the used oil in a suitable drip pan.
• Remove cover (2) at the cutter bar end
• Drain the oil.
• Reinstall cover (2) with new seal.
• Unscrew one of the two oil level inspection screws (2) on the cutter bar and add oil.
• Screw in the oil level inspection screw (2) again and tighten in securely.
• To check the oil level, align the cutter bar crosswise and lengthwise (see chapter
"Aligning the Cutter Bar").
Note
• Always check the oil level after repair work on the cutter bar.
Pos: 28.24.13.1 / BA/Wartung/Öl kontrolle_Wechs el/Ölqualität /Öl menge: siehe Kapitel @ 0\ mod_119700 7859486_78.doc @ 15531
Oil quality / oil quantity: see Chapter "Filling Quantities and Lubricant Designations for
Gearboxes"
Pos: 28.24.13.1 / BA/Wartung/Öl kontrolle_Wechs el/Altöl ordnungsge mäß entsorg en @ 0\mo d_119700811 7002_78.doc @ 15550
Note
The used oil must be disposed of correctly
Pos: 28.24.13.1 / BA/-----Seitenumbruch------ @ 0\mod_11 96175311226 _0.doc @ 416 5