Instruction Manual

20
4.3.3 Gel Doc XR System Cable Configuration
Camera connections
Connecting the cabling harnesses
1.
Locate the 6 ft USB cable. Connect one end of the USB cable connector to the USB port on the
camera. Connect the other end to the corresponding port on the rear panel on the Universal
Hood that says ‘TO CAMERA’.
2.
The camera power supply cable should be plugged into the CCD camera power connector.
3.
Connect the MZL (Motorized Zoom Lens, page 13) cable connector to the connector labeled
LENS on the rear panel of the Universal Hood.
4.
Connect the 10 ft USB cable from the Universal Hood to the PC.
5.
The main power cable that connects the Universal Hood to the power outlet.
The following table describes the cable/connectors and their designations.
Label Instrument/Connection
10 ft USB connector/cable From hood to PC
6 ft USB connector/cable From camera to hood
Camera power supply cord/power supply Camera/PWR connector
MZL (motorized zoom lens) cable Hood/LENS Din connector
Power cable Connects the Hood to the power outlet on
the wall
See the cabling diagram on the following page.
Power supply
connector
USB connector