Use Instructions

Page 15 / 27 IFU_EMB_AD_US-CA-EN_V2
6. OPERATING INSTRUCTIONS
NOTE:
Once EMBODY is attached to the insulin pen, the pen should be used just like a normal insulin
pen. Refer to the manufacturer’s injector pen user manual.
6.1 SECURITY TEST - PRIMING
WARNING
Always perform a priming (safety test) before each injection to ensure that:
Your pen and the needle are working properly,
The right dose of insulin will be injected.
If you do NOT perform the priming, you may receive too much or too little insulin (refer to the
manufacturer’s injector pen user manual).
IN AUTONOMOUS MODE OR PAIRING MODE
=>
follow the steps indicated below:
Follow the injectable insulin pen instructions for use to carry out the priming step.
At the end of the priming step, hold the
injection button pressed down:
- While EMBODY’s green LED is flashing,
- Until EMBODY emits an audible signal
(BEEP) signaling the end of the priming
step.
WARNING
If the liquid does not come out of the needle tip during the safety test, do not use the pen
and refer to the manufacturer’s injector pen instructions for use for more information to solve
the problem.
You can release the pressure on the button when the green LED stops flashing
and the “BEEP” signaling the end of priming is emitted.
IN PAIRING MODE ONLY
When the device is coupled with a compatible mobile application installed on a smartphone:
The compatible application will automatically detect a “priming” if:
- You are priming 1 or 2 unit(s), AND
- You perform your insulin injection just after the priming step (within 2 minutes)
NOTE :
“Priming” will not be displayed in the application right away: it will be displayed once the
insulin injection is done, within 2 minutes after priming.
Please refer to the application manufacturer’s instructions.
CAUTION
If the time interval between the two consecutive injections exceeds 2 minutes, the
application will automatically detect an injection instead of a priming.