Use Instructions
Page 25 / 27 IFU_EMB_AD_US-CA-EN_V2
EMBODY
is intended for use in an electromagnetic environment where radiated RF
disturbances are under control. You can help prevent electromagnetic interference by
maintaining a minimum distance between mobile and portable RF communication devices
(transmitters) and the EMBODY
device as recommended below, according to the maximum
output power of the radio communications devices
Table 22 - Recommended separation distance between portable & RF
Note: Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land
mobile radios, amateur radio, AM and FM radio broadcast and TV broadcast cannot be predicted theoretically with
accuracy. To assess the electromagnetic environment due to fixed RF transmitters, an electromagnetic site survey
should be considered. If the measured field strength in the location in which this product is used exceeds the
applicable RF compliance level above, this product should be observed to verify normal operation. If abnormal
performance is observed, additional measures may be necessary, such as re-orienting or relocating this product.
RECOMMENDED SEPARATION DISTANCES BETWEEN PORTABLE AND MOBILE RF
COMMUNICATIONS EQUIPMENT AND
EMBODY
EMBODY
is intended for use in an electromagnetic environment in which the radiated RF
disturbances are controlled. The
EMBODY
user
can help prevent electromagnetic
interference by maintaining a minimal distance between portable and mobile RF
communications equipment (transmitters) and the
EMBODY
as recommended below,
according to the maximum output power of the communications equipment.
Maximum
transmitter power
output (W)
Separation distance according to the transmitter’s frequency (m)
150 kHz to 80 MHz
P
V
d
1
5,3
80 MHz to 800 MHz
P
E
d
1
5,3
800 MHz to 2,5GHz
P
E
d
1
7
0,01
0,12 0,12 0,23
0,1
0,38 0,38 0,73
1
1,2 1,2 2,3
10
3,8
3,8
7,3
100
12 12 23
For transmitters rated at a maximum output power not listed above, the recommended
separation distance d in meters (m) can be determined using the equation applicable to the
frequency of the transmitter, where P is the maximum emission output power of the
transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1: Between 80 MHz and 800 MHz, separation distance for the highest frequency range
applies
NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is
affected by absorption and reflection from structures, objects and people.