Operation Manual

-9- -10-
When the battery symbol appears on the display or nothing is display while
inflation during measurement, you should replace with new batteries.
1. Press the snap hook on battery cover to open it.
2. Insert four "AA" batteries in the correct polarity direction.
INSTALL OR REPLACE BATTERIES
Disposal of used battery to the authorized
Collecting party subject to the regulation of
Each individual territory.
3. Replace the battery cover.
4. With the use of four alkaline "AA" batteries, you can measure approximately
o
250 times at room temperature of 22 C and inflating to around 170mmHg
once a day. But the included batteries only for test purpose may not last as
specified long period.
5. When the battery icon displays on the LCD, please replace four new alkaline
"AA" batteries, please do not mix the new and old battery together.
6. If the unit will not be used for a long period, please take out all batteries to
avoid liquid leakage damaging the unit.
Four "AA" alkaline batteries
SYMBOLS ON DISPLAY
MONTH/DATE
SYSTOLIC
HOUR/MINUTE
ATTENTION
OF ERROR
UNIT OF PRESSURE
MEMORY
LOW BATTERY
USER #
INFLATION
DEFLATION
CLASSIFY BLOOD
PRESSURE LEVEL BAR
PULSE UNIT
IRREGULAR
HEARTBEAT ICON
VALUE OF PULSE RATE
VALUE OF SYSTOLIC
DIASTOLIC
VALUE OF DIASTOLIC
1. Press and hold "SET" button until the Year
number starting flashes on LCD to release
button to enter setting mode.
2. Press " " or " " button to adjust the year, with correct year on display to
press “SET” button again then Month number is flashing.
3. Press " " or " " button to adjust the Month, with correct month on display
to press “SET” button again then Date number is flashing. Following the same
steps to adjust Date/Hour/Minute until “mmHg” or “Kpa” is flashing.
4. Press " " or " " button to select the “mmHg” as the unit of measurement,
press “SET” button again, then display “CLr All” and “no” is flashing.
5. Press “M1/M2” button to select “no” (keep the memory) or “yS” (to delete all
memory), and press “SET” button to confirm the selection, then meter turned
off for completing all setting.
NOTE: a. Select “yS” (yes) will delete all memory in both users, for retain the
memory, please select option “no”.
b. Please check and re-set Date/Time after replacing of new batteries.
DATE & TIME SETTING AND MEMORY DELETION