Operation Manual

3) Relax your hand and keep palm facing up.
4) Press the "START" button, all icons appear two
seconds on display, then flashing of “U1” or “U2”.
5) Press “MEMO” button to select the user of memory
location within 3 seconds while it is flashing.
6) Device will automatic start measurement within a few
seconds. The pressure in the cuff will automatically
inflate. When the value on LCD increase to around
150~200mmHg, and start to deflation until measurement
completed, and display results on LCD.
7) After measurement the screen will display systolic,
diastolic, and pulse/min value. Meanwhile, it will auto.
Store the measured results into user's memory.
Level indicator-
One bar for Systolic below 99 mmHg
Two bars for Systolic between 100 ~ 139 mmHg
Three Bars for Systolic between 140 ~ 159 mmHg
Four bars for Systolic above 160 mmHg
Irregular Heartbeat Detection(IHD)-
During measurement, if the sensor detects
more than twice of Heartbeat out of 25%
tolerance to your average Heart rate, the
display will turn on Irregular Heartbeat icon .
8) Press "START" button to turn off the unit.
Note:
* The value measured will be too low if you hold your hand
higher than your heart lever or too high if you hold your
hand lower than your heart lever.
* Do not bend your wrist inward.
* The unit may store up to 50 measurements per user, if more
than 50 records, it will only store latest 50 memories. (Total
100 memories for 2 users)
* During measurement avoid speaking and body/hand shaking
which may affect the accuracy of record.
* During measurement process, If you want to stop, just press
the power button to stop.
1. Press "MEMO” button, display with “U1” or “U2” flashing,
press “Memo” button again while it is flashing to select
user U1 or U2 , you are going to review.
RECALLING MEMORY
-17- -18-