Operation Manual

1. Press and hold “SET” button until the Year
number starting flashes on LCD to release
button to enter the setting mode.
2. Press the “MEMO” button to adjust the Year,
with correct year on display to press “SET
again then Month number is flashing.
Disposal of empty battery to the authorized
collecting party subject to the regulation of
each individual territory.
DATE & TIME SETTING and MEMORY DELETION
3. Press the “MEMO” button to adjust the
Month with correct month on display to
press “SET” button again then Date
number is flashing. Following the same
steps to adjust Date/Hour/Minute until
“mmHg” or “Kpa” is flashing.
4. Press “SET” button to select the “mmHg” as the unit of
measurement, press “SET” button again, then display
“CLr All” and “no” is flashing.
5. Press “Memo” button to select “no” (keep the memory)
or “yS”(to delete all memory), and press “SET” button to
confirm the selection then meter turned off for
completing all setting.
Note:
a. Select “yS” (yes) will delete all memory in both users,
for retain the memory, please select option “no”.
b. Please check and re-set Date/Time after replacing of
new batteries.
1. Put off your watch and any jewel
from your left hand.
2. Hold your left wrist with your palm facing up, apply the
cuff so that the display of monitor is in easy to view.
3. The cuff's edge should
be approximately 1/2
to 3/4 inch (1~2cm)
from your palm.
HOW TO APPLY THE WRIST CUFF
-13- -14-
Note:
* If the Low Battery Indicator appears on
the display, replace both batteries. Long-
life alkaline batteries are recommended.
* Remove the batteries if the monitor will
not be used for an extended period of time.
* With the use of two alkaline "AAA" batteries, you can
measure approximately 250 times at room temperature
o
of 22C and inflating to around 170mmHg once a day.
But the included batteries only for test purpose, it may
not last as specified long period.
* When the battery icon flashing, the device will turn off
automatically. Please replace with new batteries
immediately.
R