User manual

Biomark HPR and HPR Plus User Manual
Page 30 of 41
6.2.2 Status Report
The Status Report provides a summary of current operating conditions and
settings. It can be run manually at any time from the Reports menu, or through a
command interface. It can also be configured to run automatically by setting the
“Status Report Interval”.
Software Version number of the installed software
Read Mode Value of “Read Mode” setting
Tags in File Number of tags in current file
Memory Usage (%) Percentage of memory used
Temperature (°C) Internal temperature of the Reader
Ant. Tuning Current antenna tuning position
Ant. Current (A) Latest antenna current measurement
Ant. Voltage (V) Latest antenna voltage measurement
External Power (V) Voltage of an external charger (if connected)
Battery (V) Voltage of the internal battery
Status Report (mins) Value of “Status Report Interval” setting
Noise Report (mins) Value of “Noise Report Interval” setting
Min Ant. Current Value of “Antenna Current Low” setting
Max Bkg. Noise Value of “Backg. Noise High” setting
6.2.3 Noise
Noise data is sampled every transmit cycle (100-150 ms), and averaged over 0.5
second intervals. The 0.5 s average values are displayed on the “RF” screen, and
used to generate the Noise Report which filters that data further.
Running the Noise Report for the first time will only use data from one 0.5 s sample
period. Subsequent Noise Reports will be generated from noise data since the last
Noise Report ran. That is, the end of a Noise Report forms the start of data for the
next Noise Report.
From The start of the report period (end of previous Noise Report period)
To The end of the report period (start of next Noise Report period)
Average Max Last
FDX The average over the
reporting period
The maximum over
the reporting period
The latest reading
HDX
BKG