User manual

Biomark HPR and HPR Plus User Manual
Page 8 of 41
1.3 Supplied Equipment
1. Biomark HPR Unit, (the Reader)
2. Biomark HPR Loop Antenna
3. Fish-Shaped FDX-B RFID Key-chain Test Tag
4. Power Charger Kit (100-240V input, 24V 30W output)
5. 2 m Antenna Cable
6. 2 m USB Cable for PC Connection
7. 0.5 m USB Cable for Flash Drive connection
8. Desk Stand
9. Combined Adjustable Hand Strap & Belt-Loop
10. User Manual (on Biomark flash drive provided)
11. Custom soft case
Please ensure you have received all of the above equipment upon receipt of your
new Reader.
Optional Accessory Equipment
1. DC Power Input Cable
2. HPR to LEGACY Antenna Cable Adapter
3. Hard-shell Protective carry case
4. Hard-shell Protective remote monitoring case/enclosure
1.4 Care and Maintenance
While the HPR Reader has been designed to be as rugged and durable as
possible, please observe the following points to ensure your Reader provides many
years of trouble free service:
 Charge the battery before first using the Reader or before putting the
Reader into storage.
 The protective caps should be fitted to the connectors whenever possible to
protect them from corrosion, dust, and physical damage.
 Always properly tighten the locking collets on cables connected to the
Reader to prevent moisture entering the connectors and damaging the
contacts.
 If the Reader has become wet, ensure the connectors and their caps are dry
before removing the cables and replacing the caps. This is to avoid “locking
in” the moisture and causing corrosion damage to the contacts.
 If the Reader is exposed to salt water, rinse the entire unit with fresh water
and dry it before removing the cables.
 Clean and dry the reader before putting it back into its carry case.
NOTE: Water cannot enter into the Reader through the connectors with or without
the protective caps fitted, but the moisture could damage the terminals in the
connectors.