User's Manual

37
Chapter 6 -
Replacing and Installing System Components
Replacing and Installing System
Components
Replacing and Registering Components
When one or more of the NESS L300™ electronic components are replaced,
it needs to be electronically registered to ensure radio communication
between the components of the system. New components that requires
registration are:
• Control Unit
• RF Stim Unit
• Foot Sensor
1. Make sure the Control Unit is turned OFF.
2. Press the
and buttons simultaneously and hold them for 3
seconds.
3. The Control Unit's display will light up in 2 alternating arches
until the
registration is complete (See Figure 20).
4. If you are registering a new Foot Sensor, you need to apply pressure to
the Foot Sensor immediately after entering the registration state.
5. The letter
(short for connected) will appear on the Control Unit
indicating a successful registration.
If the component registered is the RF Stim unit - its status light will
turn green.
6
Chapter