User's Manual

22
User’s Guide
Taking the Orthosis OFF
1. Make sure the system is OFF.
2. Unhook the strap handle from the cradle and take the Orthosis off.
3. Place the electrode cover over the electrodes.
4. Charge the Control Unit and RF Stim Unit's batteries fully at the end of
your daily use (see Charging the Batteries).
Operating the Control Unit
Turning ON the system
Press the button once. The system starts in standby mode. All display
indicators light up for a few seconds while the system performs a self-test,
then the button flashes green to indicate that the system is activated.
Selecting the Mode
To select the gait mode:
After the unit is turned on, press the
button once briefly. You should
hear a beep and the
button will start to flash slowly. During stimulation
the button flashes rapidly.
To select the training mode:
After the unit is turned on, press and hold the button until a beep is
heard. The
button will start to flash slowly. In addition, the intensity
indicator displays a “t” alternating with the intensity level.
To return to standby mode:
From the gait or training mode, press the
button again briefly. You will
hear a beep and the button will stop flashing.