User Manual

105
Chapter 10 - Electronically Registering New Components
6. After registration is complete, turn on your NESS L300 Plus System. If
the new Control Unit is registered, the RF Stim Units will turn on. If you
see an RF failure indication between the Control Unit and RF Stim Units,
wait 20 minutes for the RF Stim Units to enter energy-saving mode, and
then repeat the registration procedure.
7. Once the Control Unit is registered, locate the System ID Number on the
NESS L300 Plus carrying case (for example, A334). Write the number
on the blank label on the back of the Control Unit. See Figure 71. This
ID number identifies which NESS L300 Plus System the new Control
Unit is registered to.
Registration
Error
Registration
Complete
Registration
in Process
Blank Label
Figure 71: Label on the L300 Plus Control Unit for the System ID Number.
Figure 70: Registration digital displays.