User Manual

106
NESS L300 Plus
User’s Guide
Registering a New RF Stim Unit
Set-Up
1. Turn off the L300 Plus Control Unit.
2. Remove the old RF Stim Unit from the cradle of the FS Cuff.
Caution: Do not turn on the Control Unit if the RF Stim Unit
is not in the cradle.
3. Put the old RF Stim Unit in an envelope for shipment to Bioness. Place
it at least 30 feet from the components you are registering.
4. Locate the System ID Number on the NESS L300 Plus carrying case (for
example, A334). Write the number on the blank label on the back of the
new RF Stim Unit. See Figure 72. This number identifies which NESS
L300 Plus System the new RF Stim Unit will register to.
5. Attach the new RF Stim Unit to the FS Cuff.
6. Connect the Control Unit and the new RF Stim Unit to the system charger
set during registration.
Figure 72: Label on the RF Stim Unit for the System ID Number.
Blank Label