User Manual

87
Chapter 9 - Component Maintenance and Cleaning
2. Note the “+” orientation of the old battery.
3. Remove the old battery and properly dispose of it according to your local
environmental regulations.
4. Insert the new battery. The “+” should face outward.
5. Slide the cover back into place, and tighten the screws.
6. Press the Gait Sensor pressure sensor to activate the sensor.
Remove the old battery, and properly dispose of it according to
your local environmental regulations.
Replacing the L300 Plus Control Unit Battery
The battery in the Control Unit is a rechargeable AAA battery. It should be
replaced approximately every two years.
To replace the Control Unit battery (AAA NiMH 1.2 V):
1. Remove the screw from the battery cover on the back of the Control Unit.
See Figure 49. (The screw may be under a small label. If so, gently peel
off one end of the label. Reapply the label after the battery is replaced.)
2. Remove the battery cover.
3. Note the "+/-" orientation of the old battery.