User's Manual Part 6

113
Chapter 10 - Electronic Registration
To register a replacement L300 Plus Control Unit or RF Stim Unit:
1. Turn off the L300 Plus System.
2. Simultaneously press and hold for three seconds the mode and
minus buttons. The L300 Plus Control Unit will beep when registration
begins.
3. The L300 Plus Control Unit digital display will show two alternating
GREEN arches while registration is in process. See Figure 10-2.
Registration
Error
Registration
Complete
Registration
in Process
Figure 10-2: Registration digital displays.
4. When registration is complete, (“C” for complete) will appear in the
digital display and the L300 Plus Control Unit indicator will turn GREEN
for a few seconds. See Figure 10-2. The L300 Plus Control Unit will beep.
Note: If (“E” for error) appears in the digital display, an error has occurred.
Repeat steps 2 though 4.
5. After registration is complete, turn on your NESS L300 Plus System. If
the replacement component is registered, the L300 and Thigh RF Stim
Units will turn on. If you see an RF communication failure indication, then
repeat the registration procedure.