User's Manual

6
Set-Up Instructions
Programming Components and Software
This section describes how to connect the clinician programmer and cradle, charge the clinician
programmer and launch the StimRouter application.
Connecting the Clinician Programmer and Cradle
To connect the clinician programmer and cradle:
1. Orient the clinician programmer in the configuration cradle with the touchscreen
facing up and the 24-pin connector port facing left. See Figure 6-1.
Clinician’s Programmer
Clinician Programmer
Memory Card
Charger
Clinician Programmer
24-Pin
Connector
Port
Patient Programmer
Connector
Connector Cable
Connector Cable with
Charger Adapter
Configuration Cradle
Figure 6-1. The clinician programming system set-up configuration.
Also shown is a patient programmer connected.
2. Plug the connector cable with charger adapter (on the configuration cradle) into the
24-pin connector port on the clinician programmer, with the arrows on the adapter
facing up.
Chapter 6 - Set-Up Instructions
33