User's Manual

Charging the Clinician Programmer
To charge the clinician programmer:
1. Insert the connector on the clinician’s programmer charger into the charger adapter on
the connector cable. See Figure 6-1.
WARNING: Use only the clinician’s programmer charger included in the StimRouter Clinician
Kit (Manufacturer Model No. PHIHONG, PSC11R/PSM11R).
2. Plug the charger into a power socket.
3. Allow the clinician programmer to charge. The clinician programmer can take two to four
hours to charge. When the clinician programmer is fully charged, the indicator light next
to the On/Off button will be GREEN.
Logging into the StimRouter Application
To log into the StimRouter application:
1.
Turn the clinician programmer on by pressing the on/off button on the lower right corner
of the clinician programmer. See Figure 6-2.
If the login screen does not open automatically, then, using the stylus, press “Start” and
then “StimRouter” to open the StimRouter application. Wait for the login screen to load.
See Figure 6-2.
2.
Figure 6-2. The StimRouter application login screen.
34
Clinician’s Guide