User's Manual

4. Insert the patient programmer into the configuration cradle.
Connecting the StimRouter Electrode and EPT
To connect the StimRouter electrode and EPT:
1.
Obtain an operational StimRouter electrode. Electrodes can be reused for as long as
the gel electrodes can fully adhere to the skin.
Do not remove the the reusable StimRouter electrode liner from the gel electrodes at
this time.
Set the StimRouter electrode on a flat surface with the gel electrodes facing down.
Snap the EPT into the StimRouter electrode. See Figure 6-6.
2.
3.
4.
Figure 6-6. StimRouter electrode and EPT connection.
Note: To ensure proper electrical stimulation, the EPT must be connected to the StimRouter
electrode properly. If the EPT does not work properly, then remove it from the StimRouter electrode
and reconnect it, or connect it to a new electrode.
Chapter 6 - Set-Up Instructions
37
EPT
StimRouter Electrode