User's Manual

7
Patient Records and History
Patient Records
This section reviews how to add, copy, open, modify, remove and search for a patient record;
and how to view and print a patient’s session and usage history.
Definition of Terms
Unassigned System: No patient data are stored on the EPT or patient programmer.
Assigned System: Patient data are stored on either the EPT or patient programmer.
Adding a Patient with an Unassigned System
Follow these instructions when a patient does not have a record in the clinician programmer
database and no patient data have been stored on the EPT or patient programmer, i.e., the
patient’s system is unassigned and the patient is new.
Note: “New” is only enabled in online mode when the clinician programmer is connected to an
unassigned StimRouter patient programmer and EPT.
To add a patient with an unassigned system to the clinician programmer database:
1. Make certain that the clinician programmer is connected to an operational patient
programmer and EPT. See “Set-Up Instructions” section of this guide.
2. If the EPT and patient programmer are unassigned, then the application should
automatically prompt that no patient data were found on the system. Press “OK.” See
Figure 7-1.
Chapter 7 - Patient Records and History
45