User's Manual

Adding a Patient with an Assigned System
Follow these instructions when a patient does not have a record in the clinician programmer
database but data are stored on the patient’s EPT and patient programmer, i.e., the patient’s
system is assigned. This patient may be a referral from another clinic or from a clinician using a
different clinician programmer.
To add a patient with an assigned system to the clinician programmer database:
1.
Make certain that the clinician programmer is connected to an operational patient
programmer and EPT. See “Set-Up Instructions” section of this guide.
The StimRouter application will automatically prompt that a new patient was found and
add the patient to the clinician programmer database. See Figure 7-3.
Proceed to “Programming Instructions” section of this guide.
2.
3.
Figure 7-3. Adding a patient with an assigned system.
48
Clinician’s Guide