Manualshelf

User's Manual

ManualsBrandsBioness Neuromodulation ltd. A Bioness ManualsElectronicsPatient Programmer
71727374757677787980
9
Programming Instructions
The
programming session
can
begin once
the
StimRouter electrode
with
EPT attached
is adhered,
the clinician programmer and patient programmer are set up, and the patient’s record is added
and opened. This section describes how to program stimulation and time settings, and how to
add a program, view a program, delete a program and print a program.
Stimulation and Time Settings
Programming Stimulation Settings
To program stimulation settings:
1.
Make sure that the StimRouter application is in online mode (the information icon
should be GREEN). See “Confirming Set-Up” section of this guide.
From the PATIENTS MENU, press “Open” to view the STIM SETTINGS TAB. See
Figure 9-1.
2.
Figure 9-1. Programming stimulation settings.
3.
Adjust the stimulation settings using the drop-down lists next to “Waveform,” “Phase
Duration” and “Pulse Rate.”
Chapter 9 - Programming Instructions
65