User's Manual

Adding a Program
Note: The StimRouter application must be in online mode to add a new stimulation program.
To add a program:
1.
From the STIM SETTINGS TAB or TIME SETTINGS TAB press the add program icon
on the Program Bar. See Figure 9-7.
The new program will open with default settings. The new program label (A-H) will
appear in the Program Bar.
After the program has been tested and “Stop & Save” pressed, the program will be
saved to the clinician programmer database, the patient programmer and the EPT. The
date the program was saved will appear in the center of the program bar.
2.
3.
Note: The StimRouter can support up to eight programs, labeled A-H.
Viewing a Program
To view a program:
1. From the STIM SETTINGS TAB or the TIME SETTINGS TAB, press the left or right
arrow on the Program Bar and scroll to the desired program. If only one program is
saved, then the arrows on the Program Bar will be disabled. See Figure 9-7.
Deleting a Program
Note: The StimRouter application must be in online mode to delete a stimulation program.
To delete a program:
1. From the STIM SETTINGS TAB or the TIME SETTINGS TAB, select a program to
delete.
2. Press the delete program icon on the Program Bar. See Figure 9-7.
Chapter 9 - Programming Instructions
69