User's Manual

Using a Clinic Patient Programmer
To use a clinic patient programmer:
1.
2.
3.
Connect the clinic patient programmer to the clinician programmer cradle.
Make sure the EPT and the patient programmer are charged (if not, connect them to
a charger).
Make sure the patient programmer and the EPT are no more than a few inches apart
and not touching.
From the TOOLS MENU, press “Reset Patient Programmer/EPT.”
Select “Reset the Patient Programmer” and press “Reset.”
The StimRouter application will detect the unregistered patient programmer and ask
whether you want to register this patient programmer to an EPT now. See Figure 11-1.
4.
5.
6.
Figure 11-1. Unregistered patient programmer detected.
7.
8.
9.
Press “Yes.”
Once the patient programmer and EPT are registered, press “OK.”
10. From the Patient List, press “Open” to open the patient’s record.
74
Clinician’s Guide