Instructions for use Lighting

- EN -
10 biOrb Standard LED
SAFETY INFORMATION
• Never operate the unit if the housing is defec-
tive!
• Never operate the unit if any electrical cables
are defective!
• Never carry or pull the unit by the electrical
cable.
• Route cables such that they are protected
from damage and do not present a tripping
hazard.
• Only open the unit housing or its attendant
components if this is explicitly specified in the
operating instructions.
• Only carry out work on the unit that is de-
scribed in this manual. If problems cannot be
overcome, please contact an authorised cus-
tomer service point or, if in doubt, the manu-
facturer.
• Only use original spare parts and accessories
for the unit.
• Never carry out technical changes to the unit.
• Power connection cables cannot be replaced.
If the cable is damaged, the unit must be dis-
posed of.
• Do not look directly into the light source.
• Only connect the unit if the electrical data of
the unit and the power supply correspond.
The unit data is to be found on the unit type
plate, on the packaging or in this manual.
• Protect the plug connection from moisture.
Symbols used in these instructions
CAUTION
• Indicates a possibly hazardous situation.
• Non-observance may lead to slight or minor
injuries.
NOTE
Indicates information intended to give the user
a better understanding.
Additional information
 A Reference to a figure, e.g. Fig. A.
PRODUCT DESCRIPTION
biOrb Standard LED, referred to in the following
as "unit", may only be used as specified in the
following:
• For lighting an aquarium.
• Operation under observance of the technical
data.