User's Manual

Install Hardware

Part No. 430-4G-200-00-000

4-2

4. INSTALL HARDWARE

The V-Station 4G and V-Flex 4G devices are mounted, by use of a mounting plate, either di-

rectly to a wall or to an electrical box recessed in the wall. The V-Station 4G device can be flush

mounted only. The V-Flex 4G device can be either flush or recess-mounted on a wall. Refer to

Figures 4-1 and 4-2 on the next page.

4.1. W

ALL-MOUNTING SCHEMES

4.2. I

NSTALLING A MOUNTING PLATE

The procedure for mounting a wall plate directly to a wall is as follows:

1. Hold the mounting plate onto the wall in the desired location, trace the square hole that will

be cut out, and mark the mounting screw locations. Note that for the V-Flex 4G, the large

square hole is at the bottom and for the V-Station 4G the hole is to the right.

2. Cut out the square hole with a jigsaw or drywall saw. If the V-Flex 4G device is to be recess-

mounted, cut out a hole in the drywall to accommodate the rear extension on the device

housing.

3. Drill holes for the nylon wall anchors and install them.

4. Fish wires through the wall to the square hole.

5. Align the hole in the wall plate with the hole in the wall.

6. Fasten the mounting plate to the nylon wall anchors in the wall with the provided screws.

If the V-Flex 4G device is to be recess-mounted on an electrical box, a double gang box is

required to accept the rear extension of the housing.

If mounting the V-Station 4G device to an electrical box, attach the mounting plate to a single

gang box and use wall anchors on the remaining four holes for additional security.

To install the mounting plate on to an electrical box, screw the mounting plate to the box with the

provided 6-32 screws.

When installing a recess-mounted V-Flex 4G device, be careful not to dam-

age the tamper switch, as careless handling can shear it off.

CAUTION