User's Manual

Install Hardware

Part No. 430-4G-200-00-000

4-5

4.3. I

NSTALLATION HARDWARE

Quantity Component

Hardware

1 Wall mounting plate/mullion mounting plate

6 #6-32 3/4" Philips pan-head screw

6 #6 1" Philips pan-head self-tapping screws

6 #4-8 1" nylon wall anchors

The hardware shown above is provided to mount the mounting plate to the wall and the V-

Station 4G or V-Flex 4G device to the mounting plate.

4.4. A

TTACH DEVICE TO MOUNTING PLATE

Once all the electrical connections have been made to the device, it can be attached to the

mounting plate as follows:

For the V-Flex 4G, insert the four hooked protrusions on the rear of the device into the corre-

sponding slots on the mounting plate. Hold the device against the plate and gently press it in a

downward direction to engage the hooks. Insert the star-shaped screw at the bottom center of

the mounting plate and tighten with the wrench provided. Do not over-tighten.

For the V-Station 4G, hold the device with the top slightly tilted toward you, at about a 30-degree

angle to the wall. Hold the bottom of the device against the mounting plate and lower it so that

the two hooks on the bottom of the mounting plate engage the corresponding slots on the de-

vice. When the hooks are properly engaged, the top of the device can be pivoted up against the

mounting plate. It will drop down slightly, locking itself in the closed position, and should be se-

cured in this position with the star-shaped screws in the holes at the right and left ends on the

bottom of the device. Do not over-tighten.

With the securing screws removed, the V-Station 4G device can be pivoted down 90 degrees

from the wall, as shown in Figure 4-4, to allow access for making connections, etc. The device

can be removed from the mounting plate by tilting it at an angle approximately 30 degrees to the

wall and gently lifting it up off the hooks on the mounting plate.

Pivot Point

Figure 4-4: Device Open for Installation or Service