User's Manual

Install Hardware

Part No. 430-4G-200-00-000

4-11

For installations on a wireless network, the same connection procedures should be

followed to connect the device to the wireless network devices. After the wireless

network has been installed, it needs to be set up either through SecureAdmin (see

Chapter 7 in the Operator's Manual) or through the front panel of the V-Station 4G

device.

To set up wireless operation through the front panel of a V-Station 4G device, perform

the following steps:

1. Power up the device.

2. Ensure that the wireless network is functioning.

3. Use one of these supported modes:

• WEP Open

• WPA Personal

• WPA2 Personal.

4.7.3. W

IRELESS NETWORK CONNECTIONS

4. Enter the Admin menu on the device by pressing the Left arrow and Enter keys

simultaneously.

5. Key in the Admin password (default is "0000") and press OK.

6. Select the Communications icon and press OK

7. Select "Network Interface" and press OK.

8. Select "WLAN" and press OK.

9. Select "Scan for wireless network" and press OK.

10. Select "Enable" and press OK.

11. Select "Encryption mode" and press OK.

12. Choose the type of encryption your network is using and press OK.

13. Enter the key.

14. Select "DHCP" or "Static" and press OK. If you selected "DHCP", the device

reboots. Afterwards, it will have a dynamic IP address. If you selected "Static IP",

specify an IP, a Net Mask, a Gateway, and then press OK. The device reboots.

L-1 EAS does not recommend using the "No encryption" mode.

NOTICE