User's Manual

October 15 2009 – Installation Guide Draft – Edit Purposes Only Page 17
Installation Guide –April 2010
2010
1.2.9 SAFETY PRECAUTIONS
Below are safety precautions that should be observed when operating or installing a
device.
1.2.9.1 ELECTRO-STATIC DISCHARGE
L-1 Identity Solutions recommends that Administrators inform Users of these points
during the enrollment process:
 Always use the Ridge-Lock to position a finger *before* touching the
sensor.
 Always stand on the ESD-dissipative floor covering (if installed).
 Do not touch other people or objects when touching the sensor.
 Always maintain at least 12 inches of space around yourself when
touching the sensor.
 Do not allow articles of clothing to touch the sensor.
L-1 Identity Solutions recommends that Installers always follow these points (in addition
to the points listed above):
 When installing or working on a unit, always use a grounding wrist-
strap that is connected to a quality Earth ground.
 Check the device's cabling for ground faults.
 Ensure that the device's ground connection (located on the rear of the
device) is connected to a quality Earth Ground.
1.2.9.2 DEVICE HANDLING GUIDELINES
 Do not install the device in locations where the device would be
exposed to direct sunlight, high levels of relative humidity, particulate
matter, or flammable vapors.
 Do not install the device near radiators or other heat sources.
 Do not allow magnetic objects to come within close proximity to the
device.
 Strong magnetic fields might damage the device.
 Do not let liquids Card the device.