User's Manual

Table Of Contents

Part # 430-4G-050-00-006

Install Hardware

4.4 ATTACH DEVICE TO MOUNTING PLATE

4.4.1 4G CR-PASS, 4G V-FLEX LITE AND 4G V-STATION LITE

Once all the electrical connections have been made to the device, it can be attached to the

mounting plate as follows:

For the 4G CR-Pass, 4G V-Flex Lite and 4G V-Station Lite, insert the hooked protrusions on

the rear of the device into the corresponding slots on the mounting plate. Hold the device

against the plate and gently press it in a downward direction to engage the hooks. Insert the

star-shaped screw at the bottom center of the mounting plate and tighten with the wrench

provided. Do not over-tighten.

4.5 CONNECT DEVICE TO POWER SOURCE

The 4G CR-Pass, 4G V-Flex Lite and 4G V-Station Lite can be powered by 12V DC power

source. The CR-Pass can be also powered through a Power over Ethernet (PoE) injector.

The two options for providing 12V power to 4G Lite devices are by using an external wall

plug-in adapter (Figure 4-13, or through external wiring and a mini plug (Figure 4-13).

Figure 4-5 Connections for an External Wall Adapter (4G Lite)