User's Manual
Table Of Contents
- CHAPTER 1 - INTRODUCTION
- CHAPTER 2 - PLANNING THE INSTALLATION
- CHAPTER OVERVIEW
- 2.1 PLANNING THE INSTALLATION
- 2.1.1 RECOMENDED STEPS FOR A SUCCESSFUL INSTALLATION
- 2.1.2 REQUIREMENTS
- 2.1.3 UNPACK EQUIPMENT
- 2.1.4 CHOOSING THE INSTALL LOCATION
- 2.1.5 PLAN DEVICE NETWORK
- 2.1.6 CHOOSE NETWORK TYPE
- 2.1.7 CHOOSE POWER SOURCE
- CHAPTER 3 - INSTALL SOFTWARE
- CHAPTER OVERVIEW
- 3.1 SECUREADMIN LITE SERVER
- Figure 3-1 Launch screen – SecureAdmin Lite
- Figure 3-2 Launch screen –Installation 32-bit or 64-bit
- Figure 3-3 Install Menu
- Figure 3-4 SecureAdmin Lite Server Installation Wizard
- Figure 3-5 SecureAdmin Lite Server License Agreement
- Figure 3-6 SecureAdmin Lite Server Choose Destination Location
- Figure 3-7 Database Selection
- Figure 3-8 Connecting to SQL Server option
- 3.1.1 REPAIRING AN INSTALLATION OF SECUREADMIN LITE SERVER
- 3.1.2 UNINSTALLING SECUREADMIN LITE SERVER
- 3.1.3 UPGRADING AN INSTALLATION OF SECUREADMIN LITE SERVER
- 3.2 SECUREADMIN LITE CLIENT
- Figure 3-11 Menu
- Figure 3-12 InstallShield Wizard
- Figure 3-13 Welcome Screen
- Figure 3-14 SecureAdmin Lite Client License Agreement
- Figure 3-15 SecureAdmin Lite Client Choose Destination Location
- Figure 3-16 Fingerprint Placement Feedback Option Selection
- Figure 3-17 InstallShield Wizard Finished
- 3.2.1 MODIFYING AN INSTALLATION OF SECUREADMIN LITE CLIENT
- 3.2.2 REPAIRING AN INSTALLATION OF SECUREADMIN LITE CLIENT
- 3.2.3 UNINSTALLING SECUREADMIN LITE CLIENT
- 3.2.4 UPGRADING AN INSTALLATION OF SECUREADMIN LITE CLIENT
- CHAPTER 4 - INSTALL HARDWARE
- CHAPTER 5 - SYSTEM START-UP PROCEDURES
- CHAPTER 6 - CONFIGURE DEVICE
- CHAPTER 7 - MAINTENANCE AND CLEANING
- CHAPTER 8 - TROUBLESHOOTING
- CHAPTER OVERVIEW
- 8.1 INSTALLATION ERROR MESSAGES
- CHAPTER 9 - NOTICES
- GLOSSARY
Part # 430-4G-050-00-006
© 2011 - L-1 Identity Solutions Inc. All rights reserved
Install Hardware
Figure 4-12 Connections for Internal Relay Operation
The power supply for the external relay must be chosen to match the operating voltage and
current of the external relay coil, but its voltage must not exceed the 4G Lite device's internal
relay maximum voltage rating of 250 volts.
The external relay should be connected. Note that snubber diodes (1N2007 or equivalent)
should be connected across the external relay coil and the deadbolt/door strike.
Figure 4-13 Connections for External Relay Operation
59