User's Manual
Table Of Contents
- CHAPTER 1 - INTRODUCTION
- CHAPTER 2 - PLANNING THE INSTALLATION
- CHAPTER OVERVIEW
- 2.1 PLANNING THE INSTALLATION
- 2.1.1 RECOMENDED STEPS FOR A SUCCESSFUL INSTALLATION
- 2.1.2 REQUIREMENTS
- 2.1.3 UNPACK EQUIPMENT
- 2.1.4 CHOOSING THE INSTALL LOCATION
- 2.1.5 PLAN DEVICE NETWORK
- 2.1.6 CHOOSE NETWORK TYPE
- 2.1.7 CHOOSE POWER SOURCE
- CHAPTER 3 - INSTALL SOFTWARE
- CHAPTER OVERVIEW
- 3.1 SECUREADMIN LITE SERVER
- Figure 3-1 Launch screen – SecureAdmin Lite
- Figure 3-2 Launch screen –Installation 32-bit or 64-bit
- Figure 3-3 Install Menu
- Figure 3-4 SecureAdmin Lite Server Installation Wizard
- Figure 3-5 SecureAdmin Lite Server License Agreement
- Figure 3-6 SecureAdmin Lite Server Choose Destination Location
- Figure 3-7 Database Selection
- Figure 3-8 Connecting to SQL Server option
- 3.1.1 REPAIRING AN INSTALLATION OF SECUREADMIN LITE SERVER
- 3.1.2 UNINSTALLING SECUREADMIN LITE SERVER
- 3.1.3 UPGRADING AN INSTALLATION OF SECUREADMIN LITE SERVER
- 3.2 SECUREADMIN LITE CLIENT
- Figure 3-11 Menu
- Figure 3-12 InstallShield Wizard
- Figure 3-13 Welcome Screen
- Figure 3-14 SecureAdmin Lite Client License Agreement
- Figure 3-15 SecureAdmin Lite Client Choose Destination Location
- Figure 3-16 Fingerprint Placement Feedback Option Selection
- Figure 3-17 InstallShield Wizard Finished
- 3.2.1 MODIFYING AN INSTALLATION OF SECUREADMIN LITE CLIENT
- 3.2.2 REPAIRING AN INSTALLATION OF SECUREADMIN LITE CLIENT
- 3.2.3 UNINSTALLING SECUREADMIN LITE CLIENT
- 3.2.4 UPGRADING AN INSTALLATION OF SECUREADMIN LITE CLIENT
- CHAPTER 4 - INSTALL HARDWARE
- CHAPTER 5 - SYSTEM START-UP PROCEDURES
- CHAPTER 6 - CONFIGURE DEVICE
- CHAPTER 7 - MAINTENANCE AND CLEANING
- CHAPTER 8 - TROUBLESHOOTING
- CHAPTER OVERVIEW
- 8.1 INSTALLATION ERROR MESSAGES
- CHAPTER 9 - NOTICES
- GLOSSARY
Part # 430-4G-050-00-006
© 2011 - L-1 Identity Solutions Inc. All rights reserved
Install Hardware
4.8 AUX PORT
The Aux port is a USB 2.0 auto-negotiate connector located on the bottom of the device. To
access the Aux port, the Aux port door must first be removed. Use the provided pin-in-hex
security key to remove the #6-32 security screw retaining the plastic Aux port door. Gently
remove the plastic Aux port door to reveal the USB connector.
To attach a USB memory key or other "gadget" serial device by way of the Aux port, use the
USB Type A female to USB Micro A/B male adapter cable provided in the installation kit.
The Aux port is used to transfer files to and from the device. Audio (only on 4G V-Flex Lite
and 4G V-Station Lite devices), firmware, logs, and configuration files can be transferred
quickly and easily to a device without the need for a computer.
CAUTION
Current rating of the Aux port is not to exceed 100 mA Maximum.
60