User's Manual
Table Of Contents
- CHAPTER 1 - INTRODUCTION
- CHAPTER 2 - PLANNING THE INSTALLATION
- CHAPTER OVERVIEW
- 2.1 PLANNING THE INSTALLATION
- 2.1.1 RECOMENDED STEPS FOR A SUCCESSFUL INSTALLATION
- 2.1.2 REQUIREMENTS
- 2.1.3 UNPACK EQUIPMENT
- 2.1.4 CHOOSING THE INSTALL LOCATION
- 2.1.5 PLAN DEVICE NETWORK
- 2.1.6 CHOOSE NETWORK TYPE
- 2.1.7 CHOOSE POWER SOURCE
- CHAPTER 3 - INSTALL SOFTWARE
- CHAPTER OVERVIEW
- 3.1 SECUREADMIN LITE SERVER
- Figure 3-1 Launch screen – SecureAdmin Lite
- Figure 3-2 Launch screen –Installation 32-bit or 64-bit
- Figure 3-3 Install Menu
- Figure 3-4 SecureAdmin Lite Server Installation Wizard
- Figure 3-5 SecureAdmin Lite Server License Agreement
- Figure 3-6 SecureAdmin Lite Server Choose Destination Location
- Figure 3-7 Database Selection
- Figure 3-8 Connecting to SQL Server option
- 3.1.1 REPAIRING AN INSTALLATION OF SECUREADMIN LITE SERVER
- 3.1.2 UNINSTALLING SECUREADMIN LITE SERVER
- 3.1.3 UPGRADING AN INSTALLATION OF SECUREADMIN LITE SERVER
- 3.2 SECUREADMIN LITE CLIENT
- Figure 3-11 Menu
- Figure 3-12 InstallShield Wizard
- Figure 3-13 Welcome Screen
- Figure 3-14 SecureAdmin Lite Client License Agreement
- Figure 3-15 SecureAdmin Lite Client Choose Destination Location
- Figure 3-16 Fingerprint Placement Feedback Option Selection
- Figure 3-17 InstallShield Wizard Finished
- 3.2.1 MODIFYING AN INSTALLATION OF SECUREADMIN LITE CLIENT
- 3.2.2 REPAIRING AN INSTALLATION OF SECUREADMIN LITE CLIENT
- 3.2.3 UNINSTALLING SECUREADMIN LITE CLIENT
- 3.2.4 UPGRADING AN INSTALLATION OF SECUREADMIN LITE CLIENT
- CHAPTER 4 - INSTALL HARDWARE
- CHAPTER 5 - SYSTEM START-UP PROCEDURES
- CHAPTER 6 - CONFIGURE DEVICE
- CHAPTER 7 - MAINTENANCE AND CLEANING
- CHAPTER 8 - TROUBLESHOOTING
- CHAPTER OVERVIEW
- 8.1 INSTALLATION ERROR MESSAGES
- CHAPTER 9 - NOTICES
- GLOSSARY
Part # 430-4G-050-00-006
© 2011 - L-1 Identity Solutions Inc. All rights reserved
Install Hardware
Figure 4-14 Location of Aux Port At the Bottom of the 4G Lite devices
Figure 4-15 USB Memory Key
4.9 INSTALL FERRITE CORE
In order for the 4G Lite devices to comply with FCC Class B & CISPR 22 Class B regulations,
the installer and/or end user is required to use the supplied Ferrite Material with 3 turns on
the Ethernet cables exiting the rear of all 4G CR-Pass, 4G V-Flex Lite and 4G V-Station Lite
models.
61