User's Manual

LED T ABLE S ETTINGS

Figure 32: LED Table Settings

LED Table Settings

Choosing the LED Table Settings menu item will allow the user to define

how the reader’s LED will function under specific operations. Selecting

this option will display the dialog shown in figure 30. The dropdown

selection box chooses the function (enroll, verify, idle, etc.) to modify.

Below that is each possible state for the selected operation. Line 1

represents GREEN LED, Line 2 represents RED LED, and Line 3

represents the Buzzer.

In the example shown, the ENROLL

function is chosen. The first two states are

disabled since they have no meaning

for the ENROLL function.

Both Line 1 and Line 2 are chosen to

indicate PLACE FINGER. This will turn

GREEN and RED LEDs on creating a

YELLOW LED.

The REMOVE FINGER operation is

signaled by clearing all LEDs, thus

making the LED turn off.

If a FINGER NOT DETECTED

happens, then the RED LED is shown

for 600 milliseconds.

A PASS is indicated by both turning the

LED GREEN and sounding the

BUZZER for 600 milliseconds.

To indicate a FLASHING LED, choose

the duration and set the INTERVAL

time (1350 is normal).

Figure 33: LED Table Settings

The USE TABLE checkbox indicates whether to use these setting for non-Wiegand

initiated commands (like commands coming from PC). Repeat process of other functions

then press the ACCEPT to transfer to the current unit. If the ACCEPT is not pressed, the

changes are ignored.