User's Manual

C OMMAND C ARD M ANAGER (VERIP ROX /

V ERIF LEX)

Removing Command Cards

To remove a command card, highlight the ID number in either the Enroll IDs or

the Delete IDs window and click the Delete Entry button directly beneath the

window. This will delete the template for all associated indices.

Note: You will not receive a warning when you click the button, therefore, make

sure that you have selected the correct ID.

Using Command Cards

Once you have created Enroll and Delete Command Cards, they can be used as

follows:

Enroll Command Card

To enroll a user:

1 Wave the Enroll Command Card near the front of the VeriProx /

VeriFlex unit.

The light will glow amber directing the Administrator to place his/her

finger on the unit.

2 If the Administrator is authorized to use the Command Card, the light

will glow green and the unit will beep. Continue with the next step.

If not, the light will glow red. Return to Step 1 or stop.

3 The light will flash yellow, indicating the system is ready to enroll the

new card. Wave the user card to be enrolled. The light will stop

flashing.

The light will glow amber directing the User to place his/her finger on

the unit.

4 If the print is accepted, the light will glow green and the unit will beep

indicating that the card has been enrolled.