User's Manual

U NIT P ARAMETER S ETTINGS

The string is numeric and ranges from 0 to 255.

If the box is unchecked the site code read from the proximity card will be passed

through in the Wiegand out string.

On Fail Send Inverse Parity

When you check the On Fail Send Inverse Parity box, a failed verify will result in

the Wiegand string being sent on the Wiegand out lines with inversed parity to

indicate the failure.

Enable INPUT

This option in the Wiegand Settings section will enable Wiegand INPUT when

checked and sent to the BII_UNIT. This allows all WIEGAND INPUT

communications. If this option is unchecked and sent to the BII_UNIT, all

WIEGAND INPUT data will be ignored.

Enable OUTPUT

This option in the Wiegand Settings section will enable Wiegand OUTPUT when

checked and sent to the BII_UNIT. This causes the WIEGAND OUTPUT string to

be sent whenever a WIEGAND INPUT is received (see PASS_THRU section

Wiegand Output related to Pass-Thru formats). If this option is unchecked and

sent to the BII_UNIT, all WIEGAND OUTPUT data will be ignored unless the

ALWAYS OUTPUT is selected.

ALWAYS OUTPUT

This option in the Wiegand Settings section will enable Wiegand OUTPUT on ALL

Verifications regardless of whether initiated by a Wiegand INPUT, a PC or any

other device

Pulse Width

Unchecking the USE DEFAULT option will allow the user to enter a custom Pulse

Width duration for Wiegand Output. This is NOT recommended unless the user is

very familiar with the device connected to the BII_Unit.

Pulse Interval

Unchecking the USE DEFAULT option will allow the user to enter a custom Pulse

Interval duration for Wiegand Output. This is NOT recommended unless the user

is very familiar with the device connected to the BII_Unit.

Wiegand PASS-THRU formats

When used with MV1100/MV1200 firmware version 2.50 or higher, the

VeriAdmin software allows expanded Wiegand compatibility by allowing definition