User's Manual

Veri-Series Setup Guide

Configuring Readers

1. Set up a configuration station

a. Wire the unit for power:

• V-Prox/V-Flex/V-Pass: Connect the RED pigtail wire to

9-24V DC power and the BLACK wire to power

ground.

• V-Smart: Connect the RED pigtail wire to 9-12V DC

power and the BLACK wire to power ground.

• V-Station: Connect 12.5-24V power in to the +(POS)

Weidmuller connector and the power ground to the –

(NEG) connector.

b. Optionally wire up Wiegand output to a door controller.

c. Have a computer running VeriAdmin software available.

d. Have RJ11 communications cable available.

2. Connect the reader for communication

a. Connect RJ11 to reader and DB9 to PC COM port.

b. Plug pigtail cable into reader (if not a V-Station) and

connect power to appropriate conductors identified in

the charts on pages 11 and 12.

Wiegand Ground

Wiegand Out Data1

Wiegand Out Data0

See Page 11 for Color Codes

Powe

Supply

+12 VDC

Ground

Pigtail OR

Doo

Controlle

Data 0

Data 1

Common

Earth

Ground

Com

ute

Weidmuller