User's Manual

Veri-Series Setup Guide

c. VeriAdmin should establish communication with the unit.

The Unit Status field should indicate ONLINE, you may

hear the unit beep, and other fields on the right side

should populate. If you are connecting via Ethernet, you

must first assign the unit an IP address from the unit’s

keypad and then type in the address under Ethernet

Settings and click the Refresh button.

d. If VeriAdmin shows NOT RESPONDING, check the

connections and then press the Refresh button to try

again.

e. You may assign the unit a name (default is “New

Bioscrypt Unit”) if desired.

f. The network tree shown on the left will show a small icon

representing the current unit , just below the icon

under the port you selected. Double-click on this icon to

open the Unit Parameters dialog.