User's Manual

Veri-Series Setup Guide

Mounting Readers On The Wall

1. The readers come disassembled, however, if your reader has

previously been assembled then disassemble the reader body

and smart card module (for V-Smart only) from the wall plate.

a. On V-Smart remove security screw securing smart card

module

b. For products other than V-Station, remove security screw

securing the Aux. port cover, and remove the Aux. port

cover by twisting (see graphics on page 25).

c. Remove #4-40 screw securing reader body to wall plate.

d. Remove smart card module (on V-Smart only) and

reader body by sliding up and pulling away from the

wall plate.

e. Keep screws and Aux. port cover for re-assembling the

device.

2. Define a location. A good location will have these qualities:

a. Comfortable height for finger

placement

NOTE: If readers need to be

mounted above 54” or below 48”,

please contact Bioscrypt for

available accessories to properly

readjust the angle of the reader for

optimal finger placement. Mounting

a reader above or below the

recommended height will not be

ergonomic for the user and will not

promote good finger placement on the sensor.

b. ADA considerations

48” – 54”