User's Manual

Veri-Series Setup Guide

c. Provide clearance above and below for access

d. The access hole in the wall for wiring should be less than

1 ½ inches wide so that wall plate will cover it. It should

be less than 1 ½ inches tall if mounting into dry wall so

that there is enough material to hold the anchor. The

recommended size is 1 inch wide by 1 1/8 inches tall to

match the opening in the wall plate.

e. For V-Smart, the access hole in the wall for wiring should

be less than 4 ½ inches wide so that wall plate will cover

it. It should be less than 2 ½ inches tall if mounting into

dry wall so that there is enough material to hold the

anchor. The recommended size is 3 ½ inches wide by 2

½ inches tall.

f. For V-Station, the rear of the unit will protrude past the

wall plate and into the wall approximately 1 inch

(depending on the Weidmuller connectors attached).

The access hole must be exactly the size of the hole in

the wall plate (136mm (~5 3/8”) wide by 69mm (~2 ¾”)

tall). It may be helpful to trace the edges of the hole in

the wall plate in pencil before cutting.

g. Please see pages 26 – 28 for templates for the single-

gang and double-gang mounting plates. These

templates are dimensioned in millimeters (mm).

3. Make pigtail (or Weidmuller for V-Station) wiring connections to

power, Wiegand or other connections prior to mounting wall

plate.

4. For the V-Smart, feed pigtail cable from Smart Card Module

through hole in wall plate from the front and connect to pigtail

cable already wired in wall cutout.

5. For the V-Smart, connect Smart Card Module to wall plate.

Line up four tabs, push forward and then down. Secure smart

card module with the security screw at the bottom.