User's Manual

Veri-Series Setup Guide

6. Feed main pigtail DB15 connector (not applicable to V-

Station) through wall plate from the back and proceed to

mount wall plate:

a. Optionally mount to a gang box using #6-32 screws

provided.

b. Optionally mount on wall.

i. Use 4 outer mounting points (6 for V-Station).

ii. Up to #6 screws can be accepted (screws and

drywall anchors are provided).

c. Use template provided to mark holes.

7. Attach pigtail to the reader

body (not applicable to V-

Station) and attach body

to wall plate using same

motion as for the smart

card module. Secure the

body to the wall plate with

the #4-40 screw at the

bottom. Replace the Aux.

port cover (see next page).

8. The RJ11 security cover is removed to install the reader body to

the wall mount. Once the screw is in place, the security cover

can be snapped into place using the following procedure:

With the textured side facing down,

1) place left tab into left corner groove on reader body

2) rotate cover until right tab easily slides into groove