User's Manual

Veri-Series Setup Guide

h. Choose the security level, 0 – 6 (0 = none, 1 = very high, 2

= high, … 5 = very low, 6 = Password Only). You may

press for the default (3).

i. Choose the admin level 0 – 2 (0 = user, 1 = enroller, 2 =

full admin). You may press for the default (user).

j. Enter a password for the template, if desired, or for

none.

k. If the unit is a V-Station MIFARE or V-Station iCLASS, the

next menu will ask if you would like to save the template

to the unit (1) or to a smart card (2). If saving to a smart

card, you will need to enter the current site key (it must

be numeric, and is set using VeriAdmin) and then

present an appropriate fresh or blank smart card.

l. Finally, you may elect to enroll an alternate finger with

the same ID. Press 1 for yes or 2 for no

3. Verification is as simple as:

a. Present the card to reader (unless using a V-Pass in

which case, skip to b) or enter your ID number at the

keypad if using a V-Station (when in idle mode).

b. When the light turns yellow place the finger on sensor in

same position as when it was enrolled and hold. Use the

RidgeLock to position your fingerprint on the sensor. This

will help to generate consistent finger placement. The

ridge should fit comfortably in the first crease of your

finger.

Verification is the process of comparing

a live fingerprint scan to the fingerprint

data stored during enrollment.