User's Manual

U NIT P ARAMETER S ETTINGS

MV1200 VeriSeries Port MODE

In the MV1200 based versions of the VeriSeries products, certain combinations of

ports and protocols are not allowed. To simplify this, each available mode is listed

in a dropdown. This will only be enabled if the unit is a MV1200 based unit.

In the MV1200 VeriSeries Port MODE section, select the appropriate

mode from the drop down list.

2 Click the Set button.

If the display in the lower right corner does not update, close and re-

open the window.

Warning: Changing this may cause you to lose communication with the unit(s).

If changing to mode 2 with a V-Smart, be sure you have an RS-485 converter!

Host Port Protocol

This dropdown is enabled only for older MV1100 based devices. The usual

protocol settings are as follows:

RS-232 stand alone devices

RS-485 networked devices

In the Host Port Protocol section, select the appropriate protocol from

the drop down list.

2 Click the Set button.

If the display in the lower right corner does not update, close and re-

open the window.

Warning: Changing this may cause you to lose communication with the unit(s).

Host Port and Aux Port Baud Rates

You can change the baud rates of both the Host and Aux ports to match your PC

and/or other networked devices.

In order to maintain communication, if you change the baud rate on the port you

are using, the PC’s baud rate automatically will update.

In the appropriate section (Host Port or Aux Port), select the

appropriate baud rate from the drop down list.

2 Click the Set button.

If the display in the lower right corner does not update, close and re-

open the window.