User's Manual

V ERIFICATION A CTION R ESPONSE

Figure 42: Verification Action Response

Verification Action Response

Choosing the Verification Action Response menu item will allow users to

customize the way the unit responds to a Verification Action.

Under Normal operations, the Veri-Series unit will respond based on

how a Verification Action was initiated. When a Wiegand INPUT

initiates the action, a Wiegand OUTPUT is used to respond. When a

Verification Action is initiated over a communications port by using the

Bioscrypt DLL or low-level commands (described in the MV1100 SDK),

then the response packet is

returned on the same

communication port (either HOST or AUX). This

menu allows the user to select other Verification Responses in addition to the normal

response.

The Line Trigger is a signal line that will trigger for the defined number of seconds on a

successful verification. Although not a true TTL level signal, this trigger could be used to

initiate a relay or other device. The Line Trigger is the GREEN wire on the Veri-Series

pigtail.

It is recommended that only advanced users who are working with the SDK and writing

their own custom software attempt to enable the HOST or AUX ALWAYS operations.

Please call Bioscrypt Technical Support with any questions.

Figure 43: Verification Action Dialog