User's Manual

Table Of Contents

Veri-Series Setup Guide

c. VeriAdmin should establish communication with the unit. The Unit

Status field should indicate ONLINE, you may hear the unit beep,

and other fields on the right side should populate. If you are

connecting via Ethernet, you must first assign the unit an IP address

from the unit’s keypad and then type in the address under Ethernet

Settings and click the Refresh button.

d. If VeriAdmin shows NOT RESPONDING, check the connections

and then press the Refresh button to try again.

e. You may assign the unit a name (default is “New Bioscrypt Unit”) if

desired.

f. The network tree shown on the left will show a small icon

representing the current unit

, just below the icon under the

port you selected. Double-click on this icon to open the Unit

Parameters dialog.